|
|
|
|
|
|
|
|
|
|
|
Wire Tap Instructions
|
|
- Insert wires into any two open positions.
- Insert wires until visible through plastic at back of connector.
- Squeeze with pliers.
Solder/Heat Shrink Instructions
- Slip the heat shrink tubing onto the Servo Sub wires and slide them up next to the Servo Sub body (this is done to prevent premature shrinking due to solder iron heat).
- Strip wire ends and solder/configure wires per applicable Example (1-4).
- Slide heat shrink tubing over the soldered connection and heat tubing to cause tube to 'shrink to fit'.
